ATON Source Input Wall PlateWallplate DHSIP Instrukcja Instalacji Pobierz pdf (Strona 10)

DHSIP Source Input Wall Plate

Installation

The DHSIP is designed to mount in a standard single-

gang rough-in box (J Box). Mount the unit in close

proximity to the location of the source that will be

connected to it.

Note: Do not mount the DHSIP in the same

rough-in box as high voltage devices such as

electrical outlets or switches.

After running Cat-5 and terminating the ends, route

the wire into the back of the rough-in box, connect it

to the RJ-45 connector on the rear of the DHSIP, and

mount using the 2 provided screws. See Figure 2.2.

Screw

DHSIP

Rough-In

Box

Cat-5

Stud

Screw

Figure 2.2: Installing the DHSIP

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Brak uwag

ATON Source Input Wall PlateWallplate DHSIP Instrukcja Instalacji Strona 10